About Asphalt: Known uses

Ancient times

In the ancient Middle East, natural asphalt deposits were used for mortar between bricks and stones, ship caulking, and waterproofing. The Persian word for asphalt is mumiya, which may be related to the English word mummy. Asphalt was also used by ancient Egyptians to embalm mummies.

In the ancient Far East, natural asphalt was slowly boiled to get rid of the higher fractions, leaving a material of higher molecular weight which is thermoplastic and when layered on objects, became quite hard upon cooling. This was used to cover scabbards and other objects that needed water-proofing. Statuettes of household deities were also cast with this type of material in Japan, and probably also in China.

Poured bitumen has also been used as a damp-proof course in building.

Rolled asphalt concrete

The largest use of asphalt is for making asphalt concrete for road surfaces and accounts for approximately 80% of the asphalt consumed in the United States. Roofing shingles account for most of the remaining asphalt consumption. Other uses include cattle sprays, fence post treatments, and waterproofing for fabrics.

Asphalt road surface is the most widely recycled material in the US, both by gross tonnage and by percentage. According to a report issued by the Federal Highway Administration and the United States Environmental Protection Agency, 80% of the asphalt from road surfaces' that is removed each year during widening and resurfacing projects is reused as part of new roads, roadbeds, shoulders and embankments.

Mastic asphalt

Mastic asphalt is a type of asphalt which differs from dense graded asphalt (asphalt concrete) in that it has a higher bitumen (binder) content, usually around 7-10% of the whole aggregate mix, as opposed to roller asphalt, which has only around 5% added bitumen. Another asphalt which is fast gaining global popularity is stone mastic asphalt (SMA). SMA's advantages over rolled asphalt is its high anti skid qualities due to its high aggregate density and the lack of void content (air pockets). Another advantage of SMA is its longer durability over alternative road asphalt surfaces, but its manufacture and application, if not controlled closely, can result in slippery road surfaces due to excess bitumen pooling (bleeding) onto the surface.

Asphalt emulsion

A number of technologies allow asphalt to be mixed at much lower temperatures. These involve mixing the asphalt with petroleum solvents to form "cutbacks" with reduced melting point or mixtures with water to turn the asphalt into an emulsion. Asphalt emulsions contain up to 70% asphalt and typically less than 1.5% chemical additives. There are two main types of emulsions with different affinity for aggregates, cationic and anionic. Asphalt emulsions are used in a wide variety of applications. Chipseal involves spraying the road surface with asphalt emulsion followed by a layer of crushed rock or gravel. Slurry Seal involves the creation of a mixture of asphalt emulsion and fine crushed aggregate that is spread on the surface of a road. Cold mixed asphalt can also be made from asphalt emulsion to create pavements similar to hot-mixed asphalt, several inches in depth and asphalt emulsions are also blended into recycled hot-mix asphalt to create low cost pavements.

Mixing with petroleum-contaminated soil

Sometimes asphalt can be mixed with the output from low-temperature thermal desorption.